Printable View
If its a Rheem, dont replace it with a dux, connection points will be different. Reece have a heater called everhot, made by rheem but a little cheaper and will fit straight in. Being as old as the heater is the connection points MAY vary a little.
BTW there is a Reece at Kirrawee now if you didnt know already on Oak Rd.
Thanks for that, I'm about to ring a plumber now. Glad I'm sitting down....
C'mon, we're not that bad!! There is plenty of us in the shire, just be wary of a certain mob on the outer edges of the shire (engadine/heathcote).
Ill take a stab and say that living in Sutho with an 80L HWS your in a unit???
Hey,
No, in a house actually. Why a 80L was installed I have no idea. We manage and have only run out of water on a few occasions in the shower.
I've been waiting for a few to return calls, but tradesman will be tradesman I guess. :(( Thats not being stereotypical, its just TYPICAL.
Just a point of clarification. I would not recommend that you have an 80L tank in a normal household. Peak rate power means expensive to run. I'm only advocating that since you want to keep the capital cost down and are moving.
In any other circumstance I'd strongly favour solar, gas or at least off-peak electric. Continuous electric systems are the last resort option normally - good when others won't fit etc or when you're about to move. Cheap to install but absolutely the most expensive system to run.
just one quick note... im guessing that this rheem unit is one with a anode in the top??? most of them do have a anode designed to corrode first rather than the tank itself.. during my years at work i have come across 2 leaking units with both turned out to be because of the anode rusting out as well as the bung itself thus causing a leak.. might be worth checking by popping out the top plastic cap.. you might get lucky
Hi mate,Quote:
Originally Posted by sdrob
Thanks for that - there is a plastic thing on the top middle that has a bit of water around it, although it is also dripping around the 'lid' if that makes sense, but I guess it could be coming from the anode under the cap and dripping from there. So its just a matter of prying off that rubber centre on the top? No problems will arise from doing so? (ie, a big leak I can't stop?). Thanks - theres a chance that could be the problem.....
Oh, by the way, one got back to me $795 installed for the 80L Rheem. The 'cheaper' Aquamax was still $780, so for the sake of $15, even though I want to save a bit, we will still be here at least 6mths so I might go for the rheem - never like things I've never head of (however not having heard of a HWS doesn't mean much - I don't exactly replace them often!!)
Something to remember for your next place is to check the anode before there's a leak. A good anode will very much slow down the overall corrosion of the tank and extend its life greatly. At about $45 for the anode it's a lot cheaper to replace that than to let it run out and the tank start to rust.
Anodes typically should be checked after 5 years. Shorter in areas with poor water quality. If it's severely corroded then it needs to be replaced in order to continue protecting the tank from rust.
Since we've had rusty water for 12mths or so, I have a feeling it might be past just replacing the anode.........