cutting expanded metal

Printable View

14th June 2009, 09:20 PM
Reno RSS Feed

cutting expanded metal

I need to cut some flormesh, it's expanded metal. The cuts are 5mm thick and 14mm long. There will be about 400 cuts. I'm looking at hiring a 240v circular cold cut saw. Is this the best way to go? Is there anything to watch out for using this type of saw

Read the full thread at RenovateForum.com...

All times are GMT +11. The time now is 04:15 AM.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.