Remove water cleanup -oil based stain from red gum slab

G'day all,

I bought a couple of red gum slabs from the local sawmill (he gave me the flitches as well - thanks). One slab - the smaller - is a bar top in an undercover outdoor area. I prepped it up and gave it a couple of coats of Dimension 4. After deciding the look was what I wanted I thought it better to give it a top coat of something water based but more durable. At the shop the girl talked me into getting something with a light tint for UV protection. So I bought Wattyl Deck & Exterior Timber Stain in Merbau tint. Now its on and it looks just like orange paint (sob).

This stuff is "revolutionary oil based resin core surrounded by a tough acrylic shell"

I don't want to sand it and all the character off the slab. Any ideas for a miracle chemical to clean this up?

Thanks

I think we have that on our deck. Its very orange isn;t it.:doh: At least I can blame the hubby for ours. The deck IS murbu, but the stain was unnecessary. (He went to the shop by himself. :rolleyes: I'm sure natural would have been fine. ) Unfortunately I think sanding off might be the only solution. There will still be more character underneith. :shrug: (And next time you and me will do a test before we slap it on.:doh: )

Yer. Sanding. Shouldn't take much... there's no need to start at 60grit. :rolleyes:

If the slab is natural edged, then any "wet" method of removing it may cause other problems, which can be even harder to fix. (I ruined a lovely rough-edged slab when I failed to notice the slurry from wet-sanding a finish dripping down the back. :B)

Thanks for the advice.

Other than sanding my next best option may be every Friday night drinks. All that breasting and elbowing the bar will eventually wear this stuff off won't it?

Better get on the phone now.

Darryl