Good Evening Friends,
When making typical parts for a project, rather than making copies of the pattern and gluing them to your wood.
What method would you use?
Respectfully, :)
Printable View
Good Evening Friends,
When making typical parts for a project, rather than making copies of the pattern and gluing them to your wood.
What method would you use?
Respectfully, :)
Depends on how many parts there were/detail/deadline etc. If there were a lot of parts or they were intricate or I was pushed for time I'd take the timber down to a mob I deal with and get them to knock them out on their Morbidelli CNC router. I have also used vacuum hold down template jigs, hot glue and screws to hold patterns to jigs. Horses for courses.
Mick
Good Morning Mick,
When you mentioned template you were right on target as that is what I was looking for.
Thank you for your support.
Respectfully, :)
Have a look at the Vac-Clamp website. It may be of interest to you. It shows exactly what you are after.
http://www.vac-clamp.com then goto the Vacuum Jigs section