What are the standard Floor to Cieling Heights?

Printable View

22nd January 2009, 03:40 PM
Reno RSS Feed

What are the standard Floor to Cieling Heights?

Hi guys,

Just working through a new design and trying to figure out the best floor to cieling height, and underside of roof truss...

I work it out as...
10mm under bottom sheet...
Bottom sheet width 1200 or 1350...
Top Sheet width 1200 or 1350...
10mm above top sheet...
Ceiling board thickness 10 or 13mm
Ceiling batten 22 or 30mm
Then obviosuly underside of roof truss..

Are these the normal gap allowances? or is the roof/ceiling join a "tight" corner?

Read the full thread at RenovateForum.com...

All times are GMT +11. The time now is 11:25 AM.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.