Core Drill Post Adhesive

Printable View

16th November 2008, 07:18 AM
ubeaut

Core Drill Post Adhesive

Hi All, I have a single Stainless Post (50x50 square) which I need to install to hang a glass gate from. I have core drilled a hole 150mm deep and 75mm round. I have set the post in place square with a small amount of Chemset in the bottom of the hole (about 25mm) to get it square so it is steadily in place as I had an open tube which was going to be wasted anyway. Now I need to fill the rest of the hole (100mm +) and ensure it is as strong as possible. I have had different views...

More...

All times are GMT +11. The time now is 10:37 PM.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.