Printable View
Would some patient person consider the following question. I have made a bookcase with sStained pine and used estapol as the cover. I sanded with 800 wet & dry (with water) between coats-and intended this for the top coat. What is the best way to finish? I have in mind 0000 steel wool with wax but have not used this before.
Think stoppers summed it all up rather well. http://ubb.ubeaut.com.au/ubb/wink.gif
Cheers!
Me??? I would have used spray lacquer and be done with it,
Hey Doorstop
I've just finished a Jarrah entertainment unit and was thinking of using a spray lacquer to finish it. I've not used it before, and am not sure what to use. I'm thinking of a Mirotone lacquer. I have a compressor and a good spray gun, as well as a low pressure gun and an electric gun. Which way would you go? I've put too much effort into building this entertainment unit without stuffing it up in the finishing phase. Any suggestions?
Stoppers, looks like your making me and Neil redundant on here now..hahaha.. http://ubb.ubeaut.com.au/ubb/biggrin.gif
Thanks to everyone for their help. Further questions and beginners comment.
Comments:
1) Ok, I'm skipping the wax
2) I'll use the wet & dry DRY
3) I'm going to get the Polishers Handbook
4) Early days for buying spray equiptment
Followup question:
I have read in a wwodworking text book (dated 1996) that polyuethane (and 'varnish') should be left to cure for 3 weeks before finishing which, I assume following your comment, just means the final sanding. On the other hand the tin (Wattyl Estapol) says leave minimum 8 hours between coats. Should I wait 3 weeks to finish (or when I get the Polishers Handbook - which I shall - will it all be revealed.
all I use is a CIG handysprayer, I find it easier to use than the High Pressure gun on my compressor and the electric gun I have is about as useful as a bacon sanger to Moshe Dayan!
Can you pls tell me what a CIG handysprayer is? http://ubb.ubeaut.com.au/ubb/confused.gif
------------------
Catch ya later,
Peter B.
(Corunetes)
I think it is the same as the old Little Beaver which run a fan blower and a 1 1/2" hose to the gun. Low pressure and useful for blowing spiders out of the corners of the workshop without the spray unit attached.
Cost just over a hundred bucks if this is the same unit.
------------------
: http://community.webshots.com/user/iain49
Stopper - fishing is like woodworking. You don't have to catch anything to enjoy fishing, and you don't have to make anything to enjoy woodworking. http://ubb.ubeaut.com.au/ubb/tongue.gif
------------------
Woodchuck Canuck
Good luck is the residue of good planning!