Flashing question Kingklip700

Printable View

24th October 2007, 11:33 PM
sleeping-wood

Flashing question Kingklip700

I have to flash a new roof of Kingklip700. The longitudinal flashings are recommended to be minimum overlap of 2/3 of a pan width (from the wall into the pan). This gives coverage of one rib and 2/3 of one pan. Has anyone flashed over 2 ribs or is this overkill? I have tried to show this in the attached photo. Any recommendations?
25th October 2007, 06:57 AM
Qldp

I flash over the second rib. You can,t have too much protection. It would also allow you to fasten the flashing into the top of the second rib, otherwise you have no way of screwing it down.
25th October 2007, 01:51 PM
toecutter

Quote:

Originally Posted by Qldp

I flash over the second rib. You can,t have too much protection. It would also allow you to fasten the flashing into the top of the second rib, otherwise you have no way of screwing it down.

x2

All times are GMT +11. The time now is 10:54 AM.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.