Leaking kitchen mixer tap

OK, I've done my searching, and know:

1) it will be cheaper to buy a new one, than the repair bits.
2) the tap has lasted 6 years, so leaking is about on schedule.
3) Hansa is $$$, but good, and lasts longer
4) I can probably do the swap myself (having done washers and reseating several times before)

My question is:
Most instructions regarding mixer taps go:-

1) remover the little button/brand plug
2) use Allen key to undo grub screw
3) remove handle
4) other steps...

I'm at step 3), but the handle doesn't seem interested in budging.:(
Do I need to apply LOTS of force? Do they clip on and off? Just lift off smoothly?:?

The tap is a Novelli, pretty sure it's the Syncro mixer, as seen here:
http://www.novellitapware.com.au/Pro...&SID=27&CID=24

Cheers,
Andrew

Why do you need to remove the handle??:? Never had to remove one myself to remove or fit a flickmixer.

Mick

Just cussed curiosity... there might be some interesting bit in there which I could put in a box in case I need them one day...

Or, if I can disassemble, I can at least investigate right now, versus driving or phoning around.

Cheers,
Andrew

Quote:

---

Originally Posted by arose62

Just cussed curiosity... there might be some interesting bit in there which I could put in a box in case I need them one day.........

---

Just put the whole thing in a box if you're a hoarder, or throw the whole thing out if you're not.:D It's probably seized up with soap scum, belt it with a soft faced hammer or a deadblow hammer, that ought to sort it out (or prep it for the bin:wink:)

Mick

Ohhhhh,

you're no fun:(

Hey Andrew,

The little buggers ars repairable.

Where is the leak from? the outlet or the swivelling nozzle part.

There is a specialist shop in Bentleigh (ViC) which carries all of the parts for pretty much all brands and are very helpful.

If it is the actual outlet thats running all the time then a newey is probably the easiest way to go considering the time factor for getting the right parts etc.

The handle will pull up with a little force then a large set of multigrips will get the ceramic head out.

If you have hard water thats gonna make it all the worse.

Peter