Tilt-a-Doors

Printable View

13th October 2006, 08:29 PM
Just George

Tilt-a-Doors

How difficult is it to hang a Tilt-a-Door? Is this something that can be done alone or would an offsider be required?
14th October 2006, 01:16 AM
Barry_White

Hi George

I used to hang 5 metre x 2.4metre Tilta Doors on my own but you really need to know what you are doing. If it going to be a new door there should be instructions with the fittings
14th October 2006, 01:40 PM
Just George

Thanks Barry, I'll think about it for a little while though before I do anything.
14th October 2006, 02:14 PM
Barry_White

Hi George

When your ready I'll give you a run down on the procedures for doing it. Just send me a PM.

There are two types of fittings for Tiltadoors. There is the track type for minimum head clearance and the standard type where you have plenty of head clearance. also there are different setups depending on the weight of the the door. Some only have a single spring each side and some have double springs each side.
14th October 2006, 02:27 PM
Barry_White

If you haven't got the instructions you can go here to get them. Just scroll down to Tilta Doors.

http://www.bnd.com.au/teambnd/content/?id=112

All times are GMT +11. The time now is 07:49 AM.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.