Exposing Joint Tape whilst Sanding Gyprock.. opps...

g'day guys,
i spent the weekend sanding gyprock joins, and what a horrible, dusty job :( ... all went fine, except that in some areas, the top coats were not that thick, so i sanded through onto the tape... so you can see some 'fury' sections of the exposed, "sanded" tape, where it cut back too far.... (this was especially evident where the recesed ends of the boards were not used)...

does anyone know if this will show when painted, or should I apply another top coat again, and sand away again, making sure not to expose the tape again?
cheers

D

This will show up when painted so re-top coat those few bits and sand again.

Goodluck!
Cheers
Michael

ya, thanks mic... have put another top coat on and will try it again...

much appreciated...


Dusty D