Introduction

First time on a forum for me. Carpenter & Joiner by trade and nearly ready to retire. Never done much woodturning, but recently bought an early model Woodfast lathe which has no indexing pin. Has any one information on the correct one and where I can purchase it? Info stamped on lathe bed near headstock is L 1667 70.

G'Day & Welcome to a top forum......
There are quite a good few members around Adelaide and throughout SA plus the rest of the country.....
You'll find a heap of helpful & knowledgeable blokes & ladies on the forum and for most very willing to assist.
Make sure you show off your handiwork as everyone loves a photo, especially WIP [Work In Progress] photos with build notes.
Enjoy the forum.
Enjoy your woodwork......
Cheers crowie

PS - May I suggest that you start a new thread in the general or woodturning or machinery/tool sections asking about the lathe advice.
You'll get a lot more views and thus potential answers, cheers.

Welcome to the forum.

Welcome to the forum.

Regards
Keith

Welcome to the forum.

Welcome to the forum.