-
Newbie
Hi all and greetings from lockdown Melbourne.:U:U:Uid like to firstly advise that anyone with a nobex octo it can be trued !! I just received an octo 400 last week and on the flip test and also checked with my engineer square it was out 2 mm i contacted the retailer and they refunded my money and said do what you want with it! So nothing to lose i i unscrewed the allen screw and popped it out,i then pulled the rule out stubbornly .if you do this be careful as the indent mechansm is plastic no bearings whatsoever as most people thought and has 2 pressure washers that will fly out. The plastic mechanism is attached to one side of the ruler and the other half slides into alloy housing with slots on a disc .this can be pryed out.depending which way your ruler inclines out of square you can file the plastic side and corresponding diagonal CAREFULLY and putting back together and repeat until it is perfectly square. Hope this may help someone who has the same problem. Cheers everybody
-
G'Day & Welcome to a top forum "Tricky"....
There are a stack members around Melbourne and cross Victoria plus the rest of the country.....
You'll find a heap of helpful & knowledgeable blokes & ladies on the forum and for most very willing to assist.
Make sure you show off your handiwork as everyone loves a photo, especially WIP [Work In Progress] photos with build notes.
Enjoy the forum.
Enjoy your woodwork.....
Cheers crowie
PS - Watch out for local Melbourne get togethers, great way to meet like minded forum members & network [once lockdown is finished of course]...
And please add a new thread to unpowered tools on the square issue for more to view, cheers!
-
-
-
Welcome to the forum.
Regards
Keith
-
