Top of the morning to you all

Printable View

8th August 2020, 09:18 AM
Manswani

Top of the morning to you all

New to the forum, and woodworking, and will no doubt have an endless stream of questions and pleas for help.

I have a quick one to start. I have some old Jarra timber from an old pergola that I would like to make into a side cabinet.
The timber is about 50mm thick. What is the minimum thickness I should resaw it to to reduce weight and get the most out of the timber?

Thanks and have a great day!

Siyabonga
8th August 2020, 10:21 AM
cava

Welcome.
8th August 2020, 02:56 PM
old1955

Welcome to the forum Siyabonga.
8th August 2020, 05:36 PM
crowie

G'Day & Welcome to a top forum..
There are quite a stack members around Brisbane and cross South East Queensland plus the rest of the country.....
You'll find a heap of helpful & knowledgeable blokes & ladies on the forum and for most very willing to assist.
Make sure you show off your handiwork as everyone loves a photo, especially WIP [Work In Progress] photos with build notes.
Enjoy the forum.
Enjoy your woodwork......
Cheers crowie
9th August 2020, 11:55 PM
KeithP

Welcome to the forum.

Regards
Keith
10th August 2020, 12:14 AM
JJF

Welcome to the forum
10th August 2020, 12:46 PM
verawood

Welcome

All times are GMT +11. The time now is 04:48 PM.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.