can't answer post

Printable View

14th March 2016, 07:56 PM
Rod Gilbert

can't answer post

Hi all,
I have been trying to do a reply to a post but can't getting this message.

Your submission could not be processed because the token has expired .n .

Any ideas on what to do I have tried to close the reply window and starting again but same result.
Regards Rod.
14th March 2016, 07:58 PM
Big Shed

Well, you can obviously post on the forum as you just did that.

Perhaps a bit more info would help, eg what post are you trying to respond to?
14th March 2016, 08:19 PM
Rod Gilbert
Sorry about that Big shed this was the post.
- WOODTURNING - GENERAL
- Tormek SVD - 186 inital impression Regards Rod.
14th March 2016, 08:25 PM
Big Shed

OK, I have just replied to that thread as a test, no problem.

https://www.woodworkforums.com/f8/tor...63#post1938298

I Clicked on Reply to Thread, is that what you did?
14th March 2016, 08:30 PM
Rod Gilbert

That's it Big shed. I go and have another try. I have tried a couple of times before coming here.
Regards Rod.
14th March 2016, 08:36 PM
Rod Gilbert

Went ok this time must have been holding my mouth wrong. Thank you.
Regards Rod.
14th March 2016, 08:37 PM
Big Shed

No worries, just don't hold your mouth like that again:wink:

All times are GMT +11. The time now is 03:33 AM.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.