Ok kiddies , we will try another simple quiz.
You are gluing up some wide panels and you run out of clamps. For whatever reason its not possible to get more clamps straight away.
How can you finish gluing up all of your panels?
Printable View
Ok kiddies , we will try another simple quiz.
You are gluing up some wide panels and you run out of clamps. For whatever reason its not possible to get more clamps straight away.
How can you finish gluing up all of your panels?
If you were a truckie, you could use tiedowns.
cut some timber and use as a wedge witha stop one end wedge the other to clamp panels together
http://www.woodworkforums.ubeaut.com...id=11363&stc=1
Useless infomation for the day
Alexander Graham Bell's wife and mother were both deaf .
Never happens, I always make sure I've got enough clamps before I start :p . However you could use: ratchet straps, multiple truckies hitches (ie one hitch pulling another tight, which in turn pulls a third one tight), a spanish windlass, a few bars and wedges, stack them two high in the clamps with glad wrap in between and using a few wedges to take up any discrepancies, if the panels are small enough and your clamps long enough then put them side by side in the clamps. But mostly, really, you should plan ahead and make sure you do have enough clamps to hand.
Mick
Oh thats easy... if you dont care much about damaging your bench just screw some stop blocks in place(so long as the edges have been jointed properly)I do this regulary!
Or use the sliding glue tecnique(havent tried this myself)
I use Al's cure all.
90mm framing gun.
Al :eek:
Yes, really easy for me! Just take the clamps of hubby's piece of woodwork it certianly isn't as important as mine......lol. Yes, I do agree using the bench, screw in some chocks of wood.....any way wouldn't happen to me, I plan in advance....but yes you men do seem to forget sometimes....lol...lol
Running out of clamps halfway through a glue up shows p*ss poor planning.
I always do a dry run before doing a glue up, a good time to determine clamp position and orientation and identify any potential problems.
Remember the old saying " You can never have enough clamps"Quote:
Originally Posted by kiwigeo
Having the clamps on hand (and all other necessary tools) is ideal.
Most of the answers have been posted by experienced woodies and their workarounds all work.
So the workarounds everyone has given could be valuable to newbies who are often short on tools and lack some experience planning the job or they may just be short of money. They can easily get caught without sufficient clamps.
Ashores solution is a good practical answer. It wouldnt take much to have a collection of home made clamps if money is an issue.
Micks idea of a Spanish Windlass is good.
For the benefit of any newbies lets describe a spanish windlass.
Tie a rope around the panel, with a little bit of slack.
Put a stick in the loop of the rope.
Turn the stick around lengthwise so it winds the rope up tight.
Use some packing on the edges of the panel as the rope will damage the edges when it is tight.
Kekemo's solution wouldnt help me as I dont have a husband!!
True but using my method you discover that BEFORE you start the job not DURING the job.Quote:
Originally Posted by Alias Ralph
I do a full clamp up prior to any gluing job...amazing what problems you can identify (eg clamp orientation, access for clearing squeeze out etc).