Staining gone not so good
I have made a lamp box with Tasmanian Oak. It is 6 pieces at 130mm x 130mm x 20mm to form a cube. I sanded with 80 grit then 120 then ended with 240 grit. Being new to this I seemed to have sanded across the grain. I also stained it with what was called "Black Japan". Now the stain has shown up the fault in my work.
My question is can I re-sand it and do I have to sand the whole thing again?
Or what would any of you do?
Regards Jed
I should add that I want to bee wax my cube once finished. I'm not to sure if that will hide any flaws?