G'day from Sydney

Printable View

18th November 2012, 09:42 PM
SydneyGeek

G'day from Sydney

Hi, Just joined up and looking forward to learning and possbily contributing.

I've been playing around with tools for a while, currently renovating a post-war fibro and learning heaps about working with off-square rooms.
Looking to build a small workshop and adapt a sliding mitre saw and table saw to make them more convenient and accurate to use.

Cheers!
SydneyGeek
18th November 2012, 10:31 PM
tdrumnut

Welcome to the forum
19th November 2012, 10:28 AM
crowie

G'Day & Welcome "SydneyGeek",
You'll find a heap of helpful & knowledgeable blokes & ladies on the forum and for most very willing to assist.
Thank you for the photos showing off your handiwork as everyone loves a photo, especially WIP photos with build notes.
Enjoy the forum.
Enjoy your woodworking.
Cheers crowie

PS - Take all care with the fibro on the reno!!!
19th November 2012, 07:24 PM
Christos

Welcome to the forum.
27th November 2012, 08:19 AM
JJF

Welcome to the forum

All times are GMT +11. The time now is 09:02 AM.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.