John Wright

Printable View

10th November 2011, 02:50 PM
John Wright

John Wright

G'day I am interested in turning offset burls, offset items in general and also other woodwork including pyrography. The diameter of the burls are mostly about 70cm. Interested to hear if anyone else is also interested in offset turning.
10th November 2011, 05:14 PM
Jim Carroll

Welcome to the forum John.

Good to see you are still up and about.:2tsup:
11th November 2011, 01:11 AM
JJF

Welcome to the forum
11th November 2011, 07:45 PM
Christos

Welcome to the forum. Might also advisable to post that question in this subforum.

WOODTURNING - GENERAL - Woodwork Forums
13th November 2011, 11:33 PM
munruben

Plenty of guys on the forum will be able to offer you advice on this. welcome aboard:2tsup:
14th November 2011, 11:02 PM
danny.s

Re: John Wright

Hi John

I have no idea about offset turning, but welcome to the forum.

Danny

All times are GMT +11. The time now is 09:15 AM.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.