Good Morning Friends,
Running A little late as I had a busy day.
Finding knobs with custom - threaded studs can be a challenge.
How would/do you remedy the situation?
Respectfully,
Printable View
Good Morning Friends,
Running A little late as I had a busy day.
Finding knobs with custom - threaded studs can be a challenge.
How would/do you remedy the situation?
Respectfully,
Drill them out and re-tap the threads?
Use touch latches so you don't need knobs.
P :D
Why would you want different thread on them? It's simple enough to go to the local fastener warehouse and get longer/shorter/different finish/material screws/bolts/nuts/widgets. :confused:
Mick
Liquid nails
Come to my shop, we get knobs in everyday, and I dont mean hardware.
Al :D
Good Evening Friends,
Here is an easy way to make your own. Thread a 1/4 - 20 flathead machine screw of sufficient length completely into the knob and mark the threads immediately below the knob with a permanent marker. Back out the thread till you see the mark. Apply 5 minute epoxy to the threads above the mark.
Tighten the epoxied screw into the knob, and wipe off any squeeze out.
Thank you for your support.
Respectfully,