WOODWORKING QUIZ for 25 Oct 04

Printable View

25th October 2004, 09:37 PM
Ralph Jones

WOODWORKING QUIZ for 25 Oct 04

Good Evening Friends,
While planing lumber through your benchtop planer. What is the maximum thickness that you should set you planer each time for ease of planing and making it easier on your planer?

Respectfully,
25th October 2004, 09:43 PM
echnidna

2mm in pine and 1mm in hardwood on my carbatec
27th October 2004, 03:59 AM
Bob Willson

1/2 a mm slows down my 13" Hare & Forbes
27th October 2004, 09:39 PM
Ralph Jones

WOODWORKING QUIZ for 25 Oct 04

Good Evening Friends,
According to the conversion chart 1/32" = 25.4MM and unless the chart is wrong that is what I would run for the most part till I get down to the nitty gritty and then I would go to 1/64" cuts. However I thought that 25.4 MM was equal to one inch, I'm confused.

Thank you for your support.

Respectfully,
27th October 2004, 09:45 PM
Toggy

Sorry Ralph, BUT 25.4mm equals 1 inch.

Ken
27th October 2004, 10:54 PM
Bob Willson

1/32" = .79375 mm

All times are GMT +11. The time now is 02:06 PM.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.