Safety Warning - Jet Bandsaw

Printable View

18th September 2010, 01:23 PM
Chris Parks

Safety Warning - Jet Bandsaw

The bandsaw didn't turn on when I first pressed the switch this morning, it did after I fiddled with it. Been here before with a table saw, I pull it out and the thing was full of saw dust so it got a good cleaning with air and works now. Why don't these manufacturers knowing the danger enclose the switches in a sealed cavity? The TS decided it would switch on if you dropped something on the table so I keep an eye on switches these days. You only need dust on the wrong side of the contact keeping it close to the "on" pole of the switch and the machine can start on its own.
19th September 2010, 06:02 PM
Fencepost2

Thanks for that alert Mini, could save a finger or two.
24th September 2010, 09:04 AM
AlexS

A timely warning. I've had a similar problem with a Taiwanese bandsaw, and a tablesaw that wouldn't turn off due to sawdust in the switch.
24th September 2010, 10:45 AM
issatree

The Switches.

Hi Mini, & Others,
Yes I've had the same problem, but I fixed mine.
I wrapped them in 2 thicknesses of Cling Wrap, & then screwed them down.
Have never had a problem since. The old KISS way, Keep It Simple Stupid.
Regards,
issatree.
26th October 2010, 04:48 AM
Andrew_B

Quote:

Originally Posted by issatree

Hi Mini, & Others,
Yes I've had the same problem, but I fixed mine.
I wrapped them in 2 thicknesses of Cling Wrap, & then screwed them down.
Have never had a problem since. The old KISS way, Keep It Simple Stupid.
Regards,
issatree.

had the same problem with my switches.
i put plastic flap over my BS switch, i kinda took the idea from the triton saw and router table switches...
but this flap just directs all sawdust in a different direction.
havnt had a problem since.