A new verandah in the Lockyer Valley

I am newly retired and am planning, no, I am going to build a large verandah on the back of our large home here in South East Qld. My plans were prepared by a draftsman, and council approval has been received.

I have a number of books in my library, and completed the Owner Builder Course about 3 years ago. There is a lot I don't know, however, and no doubt I will be an active member of this forum for some time.

The hardwood bearers I will be using are 75mm thick. Now my hand held circular saw cuts about 60mm I think, and I have a number of cuts to make, not to mention the rafters and the joists.

I am using predominantly hardwood. Cutting it is not going to be fun. Can anyone tell me which forum I should use to get information about the equipment I need to cut such thick timbers.

Looking forward to some good advice.

Regards

Alan

Hi and welcome to the madhouse. Try here with your question

Alan
Firstly welcome
The other place you could try for advice is the small timber milling section. Might even find a local miller who can supply you with the timber you need
I'm in the middle of a similar job but have the advantage of having a Lucas mill.
As for cutting joinery (halving jions, birdmouths etc) in the timber I'm using the trusty hand saw for things bigger than a powr saw will cut.
Have a great time doing your job

Or you could use it as an excuse to get one of these toys:U

G'day Alan and welcome to the forums.:2tsup::2tsup::2tsup:

Just follow the advice above and your verandah is sure to come together and look schmick.

Thanks for the direction, Munruben. I am looking forward to spending time on the forum.

Regards

Alan

Welcome to the forum.