re-finishing a RIMU table top

Printable View

3rd May 2010, 10:09 AM
geoff.l

re-finishing a RIMU table top

I have a large NZ Rimu table that was originally finished 15 years ago with Cabbots Danish Oil. Rimu is pretty soft, and over the years it has accumulated many dents and scratches. The oil has been touched up many times, but it is time to bite the bullit, strip it back, and start again.

I like the "soft" oiled finish, but would like something to magically harden up the underlying timber.

Any recommendations ?
4th May 2010, 10:40 PM
Tung tied

Hi Geoff,

I think you'll need to use something like an epoxy finish to give you a hard shell of protection for the softer wood underneath. A wax finish over the top, something from our friends at u-beaut, would put a nice soft lustre on it.

Harder oil based finishes will typically have some poly in them. Though not as tough as epoxy they offer more scratch resistance than just oil.

Cheers

Bryan

All times are GMT +11. The time now is 11:52 PM.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.