Changing a Roller Door Motor

Printable View

5th September 2009, 03:00 PM
Reno RSS Feed

Changing a Roller Door Motor

Wasn't quite sure where to put this thread.

Our roller door motor has given up the ghost after 10 years of good service. It's a Merlin 430R. The current Merlin products can be found here - http://www.chamberlainanz.com/index....d=23&Itemid=89

Has anyone had experience changing these over? Is it a DIY project or do I need to get a pro in.

I'm being quoted about $500 for a unit and installation (Hawthorn).

Read the full thread at RenovateForum.com...

All times are GMT +11. The time now is 11:00 PM.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.