Attaching flush pulls - a question

Printable View

21st July 2009, 04:30 PM
Reno RSS Feed

Attaching flush pulls - a question

Hi all,

just a silly novice question I guess - I have hung a large sliding door in a hallway in my home and have purchased a couple of nice 'architectural' flush pulls to go in it. The pulls are 250mmx50mmx16mm(LxWxD) stainless steel and don't act come with any pre-drilled holes for mounting and the chap at the door hardware place I purchased them from suggested that most builders just glue them in - so I guess I just wanted to confirm this to be a satisfactory method and also find out the right glue to use?

Many thanks for your time.

Beers
Mick.

Read and reply to the full thread at RenovateForum.com....

All times are GMT +11. The time now is 01:41 AM.

NavTabs provided by vBNavTabs (Pro) - vBulletin Mods & Addons Copyright © 2025 DragonByte Technologies Ltd.

Copyright © U-Beaut Enterprises 1999 - 2016. All rights reserved.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.