What to fill holes with?

[Danny]

Hi guys,

I have done a few searches on the forum before posting this but have not been able to find the right answers.

I am finishing a jarrah dining table and just want to know, what to use to fill knot holes etc. before varnishing. It is made from recycled timber and has a lot of deep knot holes that add nice character but I want to fill them with some clear filler that is also compatible with the satin varnish I will final coat over the top.

Any advice is appreciated.

Cheers,

Danny

[Hermit]

For a clear filler, maybe straight epoxy resin?
I'd actually add some fine Jarrah sawdust to the epoxy, about 50/50 by volume, to make it look like dried sap.

[Skew ChiDAMN!!]

:whs:

Personally I prefer to tint it suitably to "blend" the knot into the grain pattern. (I'll often use coffee grinds... or even instant coffee at times! :- ) Because this is an opaque finish I don't have to worry overly much about air-bubbles, etc... and can 'get away' with using 24hr Araldite or similar. (Which is not really a "cheap" method when you try to buy Araldite in sufficient bulk. :sigh: But it's usually more convenient to buy... :rolleyes: )

If you want it "crystal clear" to make the knots into features, then you need to look at a more expensive 'casting resin' type. By which I mean that it is transparent, untinted, prone to little or no shrinkage and minimal bubbles. (Either in suspension or trapped by surface tension.) Perhaps a West system epoxy resin? I'm sure others here could point to a cheaper, just as effective source of the right stuff if this is how you'd like to go.

There's also Digger's Polyester Resin from Bunnings. I use this for casting and it's nice stuff. Also cheap(ish.) :D It does have a minor tendancy to shrinkage (it is a casting resin after all) which might make it unsuitable for this application... even though their site advocates it as "Filling in knot-holes in timber table tops." :?

Might be worth trying on a knotty offcut first?

[rod1949]

:worthless:

[Danny]

Cheers guys, I will look at that. I did want to keep it clear so you can see the knots but just have it smoothed over so would probably look at the casting resin type deal.